Edge-Core ES4524C Guia de Instalação descarregar pdf (Página 35)

3-5

Installing an Optional SFP Transceiver

3. If installing a single switch only, go to “Connecting to a Power Source” at the

end of this chapter.

4. If installing multiple switches, attach four adhesive feet to each one. Place each

device squarely on top of the one below, in any order.

5. If also installing an RPS, place it close to the stack.

Installing an Optional SFP Transceiver

Figure 3-5 Inserting an SFP Transceiver into a Slot

The switches support 1000BASE-SX and 1000BASE-LX, and 1000BASE-LH

SFP-compatible transceivers. To install an SFP transceiver, do the following:

1. Consider network and cabling requirements to select an appropriate SFP

transceiver type.

2. Insert the transceiver with the optical connector facing outward and the slot

connector facing down. Note that SFP transceivers are keyed so they can only

be installed in one orientation.

3. Slide the SFP transceiver into the slot until it clicks into place.

Note: SFP transceivers are hot-swappable. The switch does not need to be powered off

before installing or removing a transceiver. However, always first disconnect the

network cable before removing a transceiver.

Note: SFP transceivers are not provided in the switch package.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 63 64

Sem comentários

Edge-Core ES4524C Guia de Instalação Página 35