Edge-Core WA6202AM EU Guia do Utilizador descarregar pdf (Página 53)

Logging In

5-3

Setting the Country Code – Units sold in the United States are configured by

default to use only radio channels 1-11 in 802.11b or 802.11g mode as defined by

FCC regulations. Units sold in other countries are configured by default without a

country code (i.e., 99). You must use the CLI to set the country code. Setting the

country code restricts operation of the access point to the radio channels and

transmit power levels permitted for wireless networks in the specified country.

Type “exit” to leave configuration mode. Then type “country ?” to display the list of

countries. Select the code for your country, and enter the country command again,

following by your country code (e.g., tw for Taiwan).

Note: Command examples shown later in this manual abbreviate the console prompt to

“AP” for simplicity.

Logging In

There are only a few basic steps you need to complete to connect the access point

to your corporate network, and provide network access to wireless clients.

The access point can be managed by any computer using a web browser (Internet

Explorer 5.0 or above, or Netscape 6.2 or above). Enter the default IP address:

http://192.168.1.1

Logging In – Enter the username “admin,” the password is null, so just press just

leave it blank and click LOGIN. For information on configuring a user name and

password, see page 6-28.

Enterprise AP#country tw

Enterprise AP#

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 331 332

Sem comentários

Edge-Core WA6202AM EU Guia do Utilizador Página 53